Outer circlip which is mounted on the brake anchor plate to fix the brake pads.
This BZ disk is suitable for the front and rear brake anchor plate of Puch Supermaxi mopeds with Grimeca wheel hub.
Details
| Fuse type | Inside |
| Nominal diameter | 6 mm |
| Manufacturer | Puch |
| Place of use | Brake anchor plate |
Suitable for the following models
| Puch |
Moped fans like you also bought:
Magura gas cable clamp / deco cable clamp Ø 5 x 6 mm
Manufacturer: Magura · Ø Cable bushing: 1.6 mm · Material: Brass · Material: Steel · Surface: nickel-plated · Thread type: M4x0.7 (standard thread) · Drive: Slot · Screw head: Lens head · Thread length: 4 mm · Ø outside: 5 mm · Total length: 6 mm · Number of components: 2 pcs
EUR 2.40
NTN wheel bearing 12/28/8 rear cast hub Leleu | Puch Maxi
Width: 8 mm · Bearing type: Deep groove ball bearing · Stock number: 6001 · Inner ring width: 12 mm · Manufacturer: NTN · Ball bearing closed: Yes · Dust protection type: 2RS - NBR contact seal on both sides · Bearing clearance: CM (special/noise-reduced) · Bearing cage: "-" Sheet steel cage ball-guided · Groove ring: No · Area of application: Standard · Material: Plastic · Material: Steel · Surface: blank · Ø inside: 12 mm · Ø outside: 28 mm
EUR 7.15
swiing® revival wheel axle set M12x1 x 185 cast rear wheel galvanized | Puch
Manufacturer: swiing® revival parts · Material: Steel · Surface: galvanized (blue) · Ø shaft: 11.9 mm · Total length: 185 mm · Thread type: MF12x1 (fine pitch thread) · Ø outside: 11.8 mm · Shank length: 100 mm · Thread length: 26 mm · Thread length: 52.5 mm · Width across flats SW: 19 mm
EUR 18.00
Not in stock
Collection only possible with online purchase and appointment.
